Placing form ties in the frame profile
|
Basic rule: |
|---|
|
▪ Fix a form tie in every form-tie sleeve that is not covered by a super plate. ▪ Always tie in the bigger (wider) of the two panels. |
|
For exceptions, see the sections headed 'Length adjustment using closures' and/or 'Vertical stacking of panels'. |
|
|
WARNING Sensitive rod steel! ➤ Never weld or heat tie rods. ➤ Tie rods that are damaged or have been weakened by corrosion or wear must be withdrawn from use. |
Note:
Seal off unneeded form-tie sleeves with Universal plugs R20/25.
|
|
Tie-rod wrench 15.0/20.0 For turning and holding the tie rods. |
Note:
Doka also offers economical solutions for creating watertight wall-ties.
.