Framed formwork Alu-Framax Xlife
The lightweight aluminium framed formwork for forming with or without a crane
- the low panel weight reduces the work-strain associated with hand-set forming, yet the panels have a high load capacity of 60 kN/m²
- the frames are made of torsion-proof hollow aluminium profiles, so can also be shifted by crane
- seamless transitioning to Framax Xlife makes operations easier to break down into crane-handled and man-handled zones, permitting flexible logistics and fast workflow on the site
- high numbers of repeat uses made possible by its excellent manufacturing quality and extra-durable Xlife-sheet
- high load capacity thanks to top-quality forged connector components
- smaller number of (expensive) closure zones, due to the consistent 15 cm increment grid
- using the single-side-operable tying system Monotec optimises workflows in confined spaces as well
- the ingeniously co-ordinated panel formats, with their logical size-grid, help you make optimum use of formwork commissioning quantities
- uuniversal panels, for practical corner configurations and column formworks
- top-quality transparent powder-coating makes for easy cleaning and uniform frame appearance, even after many repeat uses
- fast, easy planning with the Tipos planning software
- clean concrete finish from the high-grade Xlife sheet with its plastic-enhanced surface
- the ingeniously co-ordinated panel formats permit a neat joint pattern even when combining upright and horizontal panels
- no screw imprints in the concrete, as the formwork sheet is screwed on from the rear
- the neat negative frame-imprints in the concrete minimise any finishing-work
- safe vertical access with the Ladder system XS
- workplace safety on all sides with the Platform system Xsafe plus
- practical accessories – such as panel struts, lifting/repositioning devices, 3-in-1 pole tool etc. – make for safe, easy handling of the formwork
References
System
Alu-Framax Xlife
- ingeniously co-ordinated panel formats, for getting maximum utilisation from the formwork
- 15 cm grid, achieved with only five widths and two heights, simplifies planning, forming and logistics on the site
- the high-grade powder-coating on the Alu-Framax Xlife panels reliably prevents concrete adhesion
- integrated waling system: the connection profiles make it easy to attach accessories – with no obligatory fixing points
Framax Xlife sheet
- very high numbers of re-use cycles possible, thanks to plastic-enhanced surface and special sheet structure
- fewer positive imprints, due to the sheet's great resistance to scratching and vibrator damage
- fewer areas needing repair, as there is no splintering and far less swelling around nail-holes
- easy, fast (intermediate) cleaning, also using high-pressure washer
Alu-Framax pallets
The practical Alu-Framax pallets make light work of offloading the panels at the site.
Framax circular forming plate
By combining Framax circular forming plates and Alu-Framax Xlife panels, it is possible to form polygonal curves.
Combining with Framax Xlife
Combining Framax Xlife with Alu-Framax Xlife makes it possible to divide up the site into crane-handled and man-handled zones, making for flexible logistics and a fast workflow on the site.
Universal panel
The 75 cm wide Alu-Framax Xlife universal panel is used for forming columns, stop-ends and corners.
Suitable products
Platform system Xsafe plus
Doka Safety Systems
The pre-assembled, fold-out working platforms, with their integrable front/rear and side railings, l…
