Wall formwork FF100 tec

Up to a pour-height of 3.60 m, only two 20.0 form-ties are needed, thanks to

• the 80 percent higher load capacity of the I tec 20 composite formwork beam compared to conventional H20 timber formwork beams
• the stiff FF100 tec walings WU14, with their welded-on plates

Lowers commissioning quantities and forming-times because

• the small number of element widths, in a 25 cm grid, are simple to plan
• of the rapid availability made possible by the system's site-ready elements with/without form-facing
• of the improved formwork element connectors, with their optimised pull-tight and push-apart function

Superb concrete surface, with no screw imprints in the concrete, as

• the form-facing is screwed on from the rear
• the form-ties are located well inside the element, in a symmetrical pattern
• the pre-assembled beam grilles mean that any type of form-facing can be used
• the integral corner reinforcement angle ensures dependable sealing of the joint between the form-ply sheets at the outside corners

• safe vertical access with the Ladder system XS
• workplace safety on all sides with the 'Platform system Xsafe plus' or with pouring platforms
• practical accessories – such as panel struts, lifting/repositioning devices etc. – make for safe, easy handling of the formwork